Mitsubishi Electric F920GOT-K Hardware Manual page 119

GOT-F900 SERIES (CONNECTION)
2) F943 Handy GOT
Connect the cable to
the port inside the
rear cover.
When connecting via RS-232C ports, make sure that the distance between the Handy GOT and
PLC is 6m (19' 8") or less.
Name
a) External cable
b) Relay cable for PLC connection F9GT-RHCAB5-150(1.5m, 4' 11")
c) Relay cable for PLC connection Prepared by user
CN1(8-pin)
CN2(20-pin)
CN4(5-pin)
CN5(4-pin)
CN6(3-pin)
CN7(2-pin)
Note:
The connection distance between the Handy GOT and the PLC ("a) + c)" or "b)") should be within 6m
(19' 8").
Caution for CE EMC:
For compliance to CE EMC regulations it is necessary to add a
ferrite filter on the external cable for F943GOT-SBD-H-E or
F943GOT-LBD-H-E.
The filter should be attached as shown right with the filter
surrounding the external cable.
The recommended ferrite filter is the TDK ZCAT2035-0930A-BK or
equivalent.
a)
a)
For the details, refer to 5.4.3.
Model name
F9GT-RHCAB-3M(3m, 9' 10")
CN1:For power supply
CN2:For communication
CN4:For grip switch
CN5:For emergency stop switch
CN6:For keylock switch
CN7:Not to be wired
Installation and Wiring of Handy GOT 5
For the details, refer to 5.6.2.
b)
To Q Series PLC
For power supply and
operation switches
c)
To computer link unit,
microcomputer board
or another company's
PLC
For power supply and
operation switches
For the details, refer to 5.6.2.
Remarks
One side: 25-pin D-Sub
Cable outside diameter: 12.2mm(0.48")
For connecting Q CPU
PLC side: 6-pin MINI DIN
P O W E R
1 0 0 m m
( 3 . 9 3 " o r l e s s )
1
2
3
4
5
6
7
8
G R I P S W
9
. e r r i t e f i l t e r
10
5-17