GOT-F900 SERIES (CONNECTION)
The GOT-F900 is so designed as to be embedded in the panel. Install the GOT using the procedure
shown below. For the panel cut dimension, refer to the previous page.
1) Inserting the GOT into the panel face
Attach a packing to the GOT. Insert the GOT from the front of
the panel face.
c) Installation hole
2) Fixing the GOT
Hang the hook of the metal fixture (offered as accessory) to
installation hook holes in the GOT. Tighten a tightening bolt
(offered as accessory) securely in each position.
The GOT can be fixed in four positions at corners. However, to
prevent dusts and water, fix the GOT in six positions (excluding
a) Metal fixture
b) Tightening bolt
* Make sure that the tightening torque for each tightening bolt
is 0.3 to 0.5 N
(0.18 to 0.22 N
Installation and Wiring of F920GOT-K/F930GOT(-K)/F940(W)GOT 4
m when installing the F920GOT-K)
E n l a r g e d v i e w