Mitsubishi Electric F920GOT-K Hardware Manual page 308

GOT-F900 SERIES (CONNECTION)
[Change method] Change the connection type of the already created data as follows.
Operation
d)Setting the port (RS-422 or RS-232C) of the GOT-F900
Click "Auxiliary Setting" in the tree of the system environment
menu.
Click the check box of "Use Serial Port, Setup, Language, Menu
Key" to give a check mark ($).
Click "GOT Setup" in the tree of the system environment menu.
e)Set the following.
Port : RS-422
RS-232C
Type : CPU
Station No. : 00
GOT Station No. : −
In the case of F943 Handy GOT
Without regard to the port setting (RS-422 or RS-232C), the
COM0 side of the RS-232C is fixed for PLC connection.
Combinations of "Port" and "Type" are as follows.
Connection destination
Direct connection to Q CPU
Computer link unit for Q
Computer link unit for Q
a)Open GT Designer2.
b)Click the [Project]-[Open] button.
c)Open (read) the screen data to be changed.
d)On the menu, select "Common"-"System Environment".
- For the contents of setting, refer to c) of [Creation] above.
- For selection of the RS-422 on the Q Series PLCs, refer to e) of
[Creation] above.
Connection of MELSEC-Q Series PLC 11
Port Type
RS-232C
CPU
RS-422
Display (screen name)
The "Auxiliary Settings"
dialog box appears.
The "Select Project"
dialog box appears.
The "System
Environment" dialog box
appears.
11-18