Mitsubishi Electric F920GOT-K Hardware Manual page 172

GOT-F900 SERIES (CONNECTION)
5) F940WGOT
Connect the other side of the data transfer cable to the RS-232C port
(b) located in the upper position seen from the right side of the unit.
The RS-232C port (a) is offered for the PLC. It is not available for a
personal computer.
6) Handy GOT
The rear cover removal method is roughly explained below.
a) Remove the four mounting screws.
b) Open the rear cover.
c) Connect the other end of the data transfer cable to the 9-pin D-Sub (RS-232C) port.
R e a r p a n e l f a c e W h e n t h e c o v e r i s r e m o v e d ( e n l a r g e d v i e w )
S c r e w s
C o v e r
Connection of Peripheral Equipment 6
R S - 2 3 2 C p o r t
R S - 2 3 2 C ( b )
R S - 2 3 2 C ( a )
R S - 4 2 2
6-6