Wiring And Handling Of Operation Switches Sw1 To Sw4; Handling Of Operation Switches - Mitsubishi Electric F920GOT-K Hardware Manual

GOT-F900 SERIES (CONNECTION)
5.9

Wiring and Handling of Operation Switches SW1 to SW4

This section explains the wiring and the use of the operation switches and the grip switch as well as
control of the LEDs for confirming pressing of the switches.
5.9.1

Handling of operation switches

This section explains the use of the operation switches and control of the LEDs for confirming pressing
of the switches.
The switches should be wired by the user. LED indication is executed through communication.
1) Wiring the operation switches
The operation switches are assigned as follows, and connected to the PLC through an external
cable.
Connection example
H a n d y G O T
S W
c o m m o n
Pin layout
Signal name
SW-COM
SW1
SW2
SW3
SW4
In the wire colors of the F9GT-HCAB1-"M, the indication "Color 1/Color 2" indicates striped two
colors.
2) Input of operation switches
Use the operation switches of the Handy GOT as follows.
How to use the operation switches
Because the operation switches SW1 to SW4 are directly connected to inputs of the PLC, they can
be controlled freely by programs in the PLC in the same way as general inputs.
- An operation switch is taken into the PLC as a momentary type switch with N/O contact.
Example:
When a switch is wired to X0 of the PLC
X0
- When you would like to treat input of an operation switch as N/C contact or an alternate type
switch, create a proper program in the PLC.
S W 1 S W 2
1 4 1 5
1 6
0 V
X 0 X 1
F9GT-HCAB-" " " " M
14
15
16
17
18
Y0
S W 3
S W 4
1 7
1 8
X 2 X 3 X 4 X 5
P L C
External cable
F9GT-HCAB1-" " " " M
Fresh green
Sky blue
Black/white
Red/white
Green/white
Operation of
operation switch
X0
Installation and Wiring of Handy GOT 5
Conversion box
F9GT-RHCAB-" " " " M
12
13
14
15
16
ON
OFF
ON
OFF
F9GT-HCNB
SWCOM
SW1
SW2
SW3
SW4
5-34