System Configuration; Configuration For Printer Connection; Applicable Port On Got-F900; Printer Communication Setting - Mitsubishi Electric F920GOT-K Hardware Manual

GOT-F900 SERIES (CONNECTION)
21.2

System Configuration

The printer can be connected to the RS-232C port of the GOT-F900. This section explains the cable
required to connect the printer.
21.2.1

Configuration for Printer Connection

Connect the GOT-F900 to the printer.
GOT-F900
F930GOT
F940GOT
F943GOT
RS-232C port on printer side
21.2.2

Applicable port on GOT-F900

The printer can be connected to a RS-232C port on the GOT-F900 if it is not occupied with the setting
for other equipment such as a PLC, bar code reader or printer.
F940WGOT is equipped with the two RS-232C ports. Either port is applicable for connecting a printer.
21.3

Printer Communication Setting

When connecting the printer, the transmission specifications and the communication format described
below should be satisfied in the printer.
21.3.1

Transmission Specifications and Communication Format

Set the transmission specifications and the communication format of the printer as shown in the table
below.
1) Applicable printer
The printer which can be connected via ESC/P (Epson Standard Code for Printer) control code and
the RS-232C interface is applicable.
2) Transmission specifications
GOT-F900
SPEED
DATA BIT
STOP BIT
PARITY
HANDSHAKING
PRINTER
- For the setting of "DON
b) RS-232C cable
a) Printer
25-pin D-Sub, male
9-pin D-Sub, male
Setting item
GT Designer DU/WIN
Speed Speed
Data Bit Databits
Stop Bit Stopbits
Parity Parity
Handshaking Handshake [DTR/DSR], XON/XOFF
− −
' T USE/USE" of the printer, refer to section 21.5.
a) Printer
Equipped with
RS-232C I/F
Prepared by the user
Prepared by the user
Communication setting
(default value in [ ])
[300],600,1200,2400,4800,9600
[7 bits],8 bits
[1 bit],2 bits
[Even], Odd, None
[DON'T USE], USE
Connection of Printer 21
b) RS-232C cable
Remarks
(Write set value of printer.)
Select "DON'T USE" except
special cases.
21-2