Mitsubishi Electric F920GOT-K Hardware Manual page 552

GOT-F900 SERIES (CONNECTION)
3) GT Designer
This setting is enabled to the SW4D5C-GOTR-PACKE version A or later.
In the case of SW4D5C-GOTR-PACKE earlier than version A, perform the setting in the GOT-F900.
[Creation]
Operation
a)Open GT Designer.
b)Read the file of the screen data for which printer connection is to
be set.
c)Set the transmission specifications.
On the menu, select "Common"-"Auxiliary Settings"-"Project".
On the "Basic" tab, check "Use Serial Port, Setup, Language,
Menu Key".
Select the "Serial Port" tab.
To "Speed", "Hand shaking", etc., set proper contents within the
transmission specifications range for communication with the
printer.
After setting, click the [OK] button.
For the available transmission specifications, refer to section 21.3.
Connection of Printer 21
Display (screen name)
The "Project Auxiliary
Settings" dialog box
appears.
21-6