Mitsubishi Electric F920GOT-K Hardware Manual page 105

GOT-F900 SERIES (CONNECTION)
Wiring and setting procedures
This section introduces the procedure to connect the Handy GOT to connected equipment such as PLC.
1.
Preparation
Item name
Outline of Connection
Name of each Part
Outside Dimensions and
Installation
Selection and Installation
of External Cable
Processing Panel Face of
Control Box or Cabinet
Pin Layout and Signal
Allocation of Connector
for Serial Communication
and Operation Switches
Connector Conversion
Box F9GT-HCNB
2.
Wiring
Item name
Outline of Internal Wiring
Wiring for 24V DC Power
Supply and Class D
Grounding
Wiring and Handling of
Operation Switches SW1
to SW4
Wiring and Handling of
Emergency Stop Switch
(ES1)
Handling of grip switch
(excluding RH model)
Handling of grip switch
(RH model only)
Handling of Keylock
Switch
3.
Setting
Item name
Setting of Connected
Equipment for GOT
You can learn the outline of the connection method.
You can learn the name of each part of the Handy GOT.
You can learn the outside dimensions of the Handy GOT and the
installation method according to the operation type.
You can select cables. This section introduces the procedure to connect
cables to the Handy GOT.
When preparing a cable, you can learn signal names of connectors and
untied wires.
You can learn the dimension of the processing on the panel face required
to use the Handy GOT with attachment to and removal from the panel face.
This section introduces types of relay cables.
You can check the signal allocation of connector or untied wires when
preparing a cable.
You can learn the name of each part, installation, and connector
specifications.
You can check block diagrams of portions requiring wiring and the
internal wiring.
You can check the methods to wire the 24V DC power supply and
perform Class D grounding.
You can learn how to use and wire the operation switches. (Setting in the
screen creation software is required.)
You can learn how to use and wire the emergency stop switch.
You can learn how to use the grip switch.
You can learn how to use the grip switch.
You can learn how to use the keylock switch (RH model only).
Using the screen creation software, you can enable the operation switch
LEDs and the grip switch.
Installation and Wiring of Handy GOT 5
Description
Description
Description
1
2
Reference
5.1
5.2
5.3
3
5.4
5.5
4
5.6
5.16
5
Reference
5.7
6
5.8
5.9
7
5.10
5.11
5.12
8
5.13
Reference
9
5.14
10
5-3