Mitsubishi Electric F920GOT-K Hardware Manual page 196

GOT-F900 SERIES (CONNECTION)
3) GT Designer
[Creation]
Operation
a)Open GT Designer.
b)Click the [NEW] button.
c)Set the following.
GOT type: F940WGOT (480 × 234)
F940GOT (320 × 240)
F930GOT (240 × 80)
PLC type:MELSEC-FX
MELSEC-A
MELSEC-QnA, Q
MELSEC-Q (Multi)
Computer
Selection of "GOT type"
GOT type
F940WGOT(480×234)<WIDE>
F940GOT(320×240)
F930GOT(240×80)
Click [OK].
d)Set CPU direct connection (RS-422/RS-232C) of the GOT-F900.
This setting is enabled in the SW4D5C-GOTR-PACKE version A
or later.
Click the check box of "Use Serial Port, Setup, Language, Menu
Key" to give a check mark ($).
Click the "Setup" tab.
In the case of SW4D5C-GOTR-PACKE earlier than version A,
perform the setting in the GOT-F900.
(Set the connection in "CONNECTION" in the GOT-F900.)
For the setting method, refer to "1) GOT-F900 Series" on the
previous page.
Connection of Two or More GOT Units 7
Model name
F940WGOT
F940GOT
Handy GOT
F930GOT
F930GOT-K
Display (screen name)
The "Select Project"
dialog box appears.
The "GOT/PLC Type"
dialog box appears.
The "Project Auxiliary
Settings" dialog box
appears.
7-16