GOT-F900 SERIES (CONNECTION)
4.3
Outside Dimensions and Panel Face Processing
This paragraph explains the specifications of outside dimensions of the GOT-F900, and the panel cut
dimensions in processing the panel face.
4.3.1
Panel Cut Dimension
On the panel face, drill an installation hole of the dimension shown below.
In addition to the panel cut dimension, the space for metal fixture is required by approximately 10 mm in
the left, right, up and down directions respectively.
For the details, refer to "2) Installation space" below.
L a t e r a l i n s t a l l a t i o n
1) Panel cut dimension
W
H
-
Make sure that the processing accuracy is 0 to +1 mm.
-
Make sure that the thickness of the installation panel is 5 mm or less.
2) Installation space (Reference)
For the details, refer to the next page.
W2
H2
-
The dimension above is offered for reference.
Installation and Wiring of F920GOT-K/F930GOT(-K)/F940(W)GOT 4
S p a c e f o r m e t a l f i x t u r e
W
W 2
F920GOT-K
F930GOT
92 (3' 63")
137 (5' 39")
119 (4' 69")
66 (2' 60")
F920GOT-K
F930GOT
109 (4' 29")
137 (5' 35")
119 (4' 69")
85 (3' 35")
L o n g i t u d i n a l i n s t a l l a t i o n
H
H 2
( . 9 3 0 G O T , . 9 4 0 W G O T o n l y )
F930GOT-K
155 (6' 10")
153 (6' 02")
170 (6' 69")
121 (4' 76")
F930GOT-K
174 (6' 85")
172 (6' 77")
189 (7' 44")
140 (5' 51")
Unit: mm (inches)
F940GOT
F940WGOT
206 (8' 11")
124 (4' 88")
Unit: mm (inches)
F940GOT
F940WGOT
225 (8' 86")
143 (5' 63")
4-8