Serial Line Configuration - Fagor CNC 8060 Installation Manual

2.3.11
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·82·

Serial line configuration.

RSTYPE
Type of serial line.
Possible values: RS232 / RS485 / RS422.
Default value: RS232.
Associated variable: (V.)MPG.RSTYPE
Type of serial line. Standard configuration for RS232 and full-duplex configuration for RS422.
For the HBLS (portable operator panel) select RS422.
i
In the RS485, the CNC uses the same signal to control "send data" and "receive data", therefore
sending is disabled while receiving. In order to ensure proper communication, an 8-ms delay is required
from when the CNC stops sending till it is ready to receive data. At the slaves connected to the CNC,
this delay time must be set from when data is received till it is sent. An external RS232/RS485 adapter
should be used if this delay cannot be set at the slave.
I n s ta ll a t io n ma n u a l.