Axis Configuration For Lathe Type Machines - Fagor CNC 8060 Installation Manual

2.5.6
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·160·

Axis configuration for lathe type machines.

FACEAXIS
Face axis on a lathe.
Parameter valid for a linear axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.FACEAXIS.xn
See axis machine parameters LONGAXIS.
LONGAXIS
Longitudinal axis on a lathe.
Parameter valid for a linear axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.LONGAXIS.xn
On turning machines, you must indicate which one is the longitudinal axis and which one
is the cross axis.
Typical lathe setting:
X axis. FACEAXIS = Yes
Z axis. FACEAXIS = No
Rest of the axes. FACEAXIS = No
Typical Mill setting:
All the axes. FACEAXIS = No
These parameters only affect the axes that can work in lathe mode. If it is a combined
machine and any or several milling axes can work as lathe, it is necessary to set these
parameters. In some cases, the same axis can work as a face axis (FACEAXIS=Yes) and
as longitudinal axis (LONGAXIS=Yes) and consequently, both parameters must be set to
Yes.
I n s ta ll a t io n ma n u a l.
LONGAXIS = No
LONGAXIS = Yes
LONGAXIS = No
LONGAXIS = No