Configure The Jog Keys - Fagor CNC 8060 Installation Manual

2.7.2
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·244·

Configure the jog keys.

JOGKEYDEF
JOGKEYBD2DEF
··
JOGKEYBD8DEF
Tables to configure the jog keys.
These parameters may be used to configure the jog keypad of each panel. Parameter
JOGKEYDEF corresponds to the first jog panel, JOGKEYBD2DEF to the second one and
so on.
The CNC numbers the operator panels following the order (sequence) that they occupy in
the CAN bus (Address switch). The first jog panel will be the one with the lowest number
and so on.
JOGKEYDEF n
JOGKEYBD2DEF n
··
JOGKEYBD8DEF n
Axis and moving direction of each jog key.
Associated variable: (V.)MPMAN.JOGKEYDEF[jk] / (V.)MPMAN.JOGKEYBDkbDEF[jk]
Parameter included in the JOGKEYDEF table.
There is one table for each jog keypad. Each one of these parameter sets the function of
each JOG key. The number of jog keys available depends on the type of keyboard that may
sometimes have up to 15 keys. The CNC always offers 15 parameters; if the jog keypad has
fewer keys, the parameters that do not have any keys associated with them will be ignored.
The relationship between these parameters and the jog keys is the following.
OP-PANEL
1 2 3
4 5 6
7 8 9
10 11 12
13 14 15
OP-PANEL
CNC
OFF
X Y Z
CSS
jog +
80 90 100
10 1 1 10 m/min 70 110
100 100 60 120
1000
_ 10000 50 130
+
40 140
30 150
20 160
10 170
_ 4 180
4 5 6
2 0 200 190
FEED
ZERO SINGLE
RESET
1 2 3
4 5 6
7 8 9
10 11 12
13 14 15
I n s ta ll a t io n ma n u a l.
LCD-10K
1 2 3
7 8 9
4 5 6