User Subroutines Associated With Functions G8000 To G8999 - Fagor CNC 8060 Installation Manual

14.19 User subroutines associated with functions G8000 to G8999.

14.
14.19.1 Configure the subroutines.
CNC 8060
CNC 8065
(R : 1709)
EF
·640·
The CNC lets the user define up to 1000 subroutines, common to all channels and associated
with functions G8000 through G8999, so when the CNC executes one of these functions,
it will execute its associated subroutine. These subroutines may be executed either in a non-
modal or modal way and it also allows resetting the local parameters of the subroutine.
These subroutines are loaded into RAM memory when they are executed for the first time.
If there is no room in RAM, the CNC will issue a warning and it will execute the subroutine
from the disk. At the end of the program (M30), if no other channel is executing subroutines,
the CNC deletes them from its RAM memory. This way, if a user subroutine is edited or
modified, the CNC assumes the changes the next time it executes it.
Some of these subroutines have a function pre-assigned by Fagor, being ProGTL3 language
macros. If one of these G functions is programmed, the CNC executes the corresponding
macro and not the subroutine.
If this version is updated, the CNC behaves as follows.
• For the two first two installation options, the CNC will only copy the subroutines in the folder
..\Mtb\Sub if they do not already exist.
• In the third installation option, "rename previous version and install it completely", the CNC always
updates the subroutines.
Name and location of the subroutine.
The subroutines associated with functions G8000 to G8999 will have the same name as the
function (without an extension) and they will be saved in the folder ..\Users\Sub.
G8000 The subroutine G8000 will be associated.
G8001 The subroutine G8001 will be associated.
· · ·
G8999 The subroutine G8999 will be associated.
I n s ta ll a t io n ma n u a l.