1.3.2
1.
CNC 8060
CNC 8065
(R
: 1709)
EF
·52·
Software update and incompatibilities (8065).
Version V4.25.
Unit change in machine parameter FTIMELIM, related to HSC machining.
In earlier versions, parameter FTIMELIM was programmed in milliseconds. From this version
on, this parameter is set in percentage.
Version V5.31.01.
Apply or not tool radius compensation in G00.
In this version, movements in G00 do not apply tool radius compensation. This has been
corrected in later versions with parameter G00COMP.
Version V5.40.
New software option "third-party CANopen".
From this version one, if a machine is using some non-Fagor CANopen module, the CNC
will not recognize it and it will issue the corresponding error message when initializing the
CAN bus.
Extended scope of the software option "Probing canned cycles".
The software option "Probing canned cycles" is now called "Probe". From this version on,
functions G100, G101, G102, G103 and 104 need this software option.
I n s ta ll a t io n ma n u a l.