Plc Type - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
2.3.36

PLC type.

PLCTYPE
PLC type.
Possible values: IEC / IEC+Fagor / Fagor.
Default value: IEC.
Associated variable: (V.)MPG.PLCTYPE
This parameter selects the type of PLC to be used; the Fagor one, the standard IEC-61131
or both. The following table shows who is affected by the startup (RUN) and stop (STOP)
of the PLC depending on this parameter as well as the status of the mark PLCREADY.
PLCTYPE
IEC
IEC+Fagor
Fagor
2.3.37 Rename the axes and the spindles.
RENAMECANCEL
Cancel the name change for the axes and the spindles.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)MPG.RENAMECANCEL
The #RENAME instruction may be used to rename the axes and spindles via part-program
or MDI/MDA mode. This parameter indicates whether the CNC keeps or cancel the names
of the axes and spindles (#RENAME) after a reset or at the beginning of a new part-program
in the same channel.
After turning the CNC off and on, the axes and spindles always keep their new name, except
after a checksum error or after validating the machine parameters that involve restoring the
original configuration of channels, axes or spindles. In either case, the axes and the spindles
will recover their original names.
RUN STOP
IEC Fagor IEC
Yes No Yes
Yes Yes Yes
No Yes No
PLCREADY
Fagor IEC Fagor
No ON - - -
Yes ON ON
Yes OFF ON
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·117·