Name: Sub_Probe_Piece_Begin.fst; Sub_Probe_Piece_End.fst; Subroutines Associated With The Part Measuring Cycle - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
14.7

Subroutines associated with the part measuring cycle.

The subroutines supplied by Fagor provide basic probe management, so they should be adjusted and
configured appropriately by the OEM. Fagor provides the subroutine Sub_Probe_Tool_Begin.fst
associated with probe input 1 and the subroutine Sub_Probe_Piece_Begin.fst associated with probe
input 2.
The part measuring cycle, for both the ISO and the editor, has two associated subroutines
that the CNC executes before and after the cycle. These subroutines can be used to enable
the probe and indicate if it is in safe mode.
Name.
Sub_Probe_Piece_Begin.fst

Sub_Probe_Piece_End.fst

Subroutines and M functions defined in the cycle.
Up to 4 M functions may be defined in each probing cycle to be executed before the cycle
and another 4 M functions to be executed afterwards. All these functions may have a
subroutine associated with them. When starting the execution, the cycle executes first the
subroutine Sub_Probe_Piece_Begin.fst and then the M-before functions with their
associated subroutines. At the end of the execution, the cycle executes first the M-after
functions with their corresponding associated subroutines and then the subroutine
Sub_Probe_Piece_End.fst.
Management of the PROBE1ENA/PROBE2ENA marks in the
subroutine.
These mark indicate that the probe has is enabled. It is recommended that the OEM
manages both marks from the subroutine Sub_Probe_Piece_Begin.fst, so that the execution
waits until the mark is active.
Management of the PROBE1MONIT/PROBE2MONIT marks in the
subroutine.
These marks are associated with the safe mode of the probe. It is recommended that the
OEM manages both marks from the subroutine Sub_Probe_Piece_Begin.fst to warn, should
they be deactivated, that the probe is in non-safe mode.
14.7.1 Configure the subroutines.
Name and location of the subroutine.
The name of the subroutine is Sub_Probe_Piece_Begin.fst and Sub_Probe_Piece_End.fst.
Both subroutines must be saved in the folder ..\Mtb\Sub. All channels use the same
subroutines.
Since it is an OEM subroutine with an .fst extension, the CNC loads this subroutine into the
RAM of the CNC. See
Meaning.
Subroutines associated with the start of the part measuring cycle.
Subroutines associated with the end of the part measuring cycle.
"14.1 Run subroutines from RAM (extension *.fst)."
14.
CNC 8060
on page 617.
CNC 8065
(R
EF
: 1709)
·625·