Software Installation At The Cnc - Fagor CNC 8060 Installation Manual

SOFTWARE INSTALLATION.
1.1

Software installation at the CNC.

Fagor delivers the CNC with the software properly installed. Both at a CNC and at a PC
(simulator), the necessary files for the CNC are located in the following folder. See
"1.6 Software configuration."
8060 CNC
8065 CNC
The CNC software must not be re-installed or modified in any way without the express consent from
Fagor Automation. Fagor Automation shall not be held responsible for any personal injuries, physical
or material damage suffered or caused by the CNC due to software manipulation.
Software protection at the CNC. System with a write-protected (read-only) disk.
Fagor delivers the unit with the disk that is write-protected except for the folders or files that
must be unprotected for the normal operation of the CNC. The disk has been pre-configured
with three access modes, each offers a different protection level. See
and software protection at the CNC."
Software setting.
It is up to manufacturer to set up the CNC and adapt it to his machine. The manufacturer
can also customize the CNC's look using the screen customizing program FGUIM. Before
using this tool, read the relevant documentation carefully.
CNC setting; the MTB folder.
Both at a CNC and at a PC (simulator), the OEM has the folder ..\MTB to save the
modifications done at the CNC; such as the PLC program, the machine parameters, etc. The
CNC manages the MTB folders as follows.
• No MTB folder appears when installing the software for the first time. On system startup
and depending on the validation code, the system will move the corresponding folder from
..\CONFIGURATION to the CNC8070 (or FAGORCNC) and will rename it MTB.
• When changing the validation code, the system will return the MTB folder to the
..\CONFIGURATION folder and will give it its old name (MTB_M, MTB_T, etc); then, it
will move the corresponding folder from ..\CONFIGURATION to CNC8070 (or
FAGORCNC) and will rename it MTB.
• If the OEM has created the MTB folder manually, for example by copying it from a backup,
the system will not make any changes on power-up nor when modifying the validation
code.
on page 55.
C:\FAGORCNC and its corresponding subfolders.
C:\CNC8070 and its corresponding subfolders.
on page 45.
1
"1.1.1 Work modes
CNC 8060
CNC 8065
(R : 1709)
EF
·43·