Rapid Traverse For The Automatic Mode - Fagor CNC 8060 Installation Manual

2.6.6
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·202·

Rapid traverse for the automatic mode.

FRAPIDEN
Rapid traverse of the axis for movements in automatic mode.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 500000.0000 mm/min.
Possible values (2): From 0 to 19685.03937 inch/min.
Possible values (3): From 0 to 500000.0000 degrees/min.
Possible values (4): From 0 to 1388.8889 rpm.
Default value: 0.
Associated variable: (V.)[ch].MPA.FRAPIDEN[set].xn
Maximum feedrate of the axis for the program being executed, when the rapid traverse for
the automatic mode is active (parameter RAPIDEN). If the parameter is set with a "0" value,
the feedrate is not limited. The value of this parameter must always be lower than that of
axis parameter G00FEED.
This parameter does not the movements programmed in G00 or the threads. Movements
in G0 are carried out at the feedrate set in parameter G00FEED. The threads are executed
at the programmed feedrate.
The rapid traverse cannot exceed the value set in axis parameters G00FEED or FRAPIDEN
of the channel or the maximum feedrate set by PLC (variable (V.)PLC.G00FEED). Rapid
traverse cannot exceed the value set in axis parameter MAXFEED of the channel and the
active feedrate set by PLC (variable (V.)PLC.F).
Variable. Machine parameters.
(V.)PLC.G00FEED G00FEED (axis)
0 10000
0 10000
4000 10000
7000 10000
12000 10000
I n s ta ll a t io n ma n u a l.
Rapid feed.
FRAPIDEN (axis) G00
0 10000
6000 10000
6000 4000
6000 7000
6000 10000
G01, G02, ···
10000
6000
4000
6000
6000