Configuring The Axes Of The Channel - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
2.4.2

Configuring the axes of the channel.

CHNAXIS
Number of axes of the channel.
Possible values: From 0 to 28.
Default value: 3.
Associated variable: (V.)[ch].MPG.CHNAXIS
This parameter sets the number of axes of the channel, whether they are servo-controlled
or not.
A channel may have initially associated with it one, several or no of the axes defined in the
system. In any case, the number of axes assigned to the channel cannot be higher than the
number of axes of the system, defined by parameter NAXIS. The sum of the axes assigned
to the channels cannot exceed the number of axes of the system either.
It is possible to change the configuration of the axes of a channel via part-program, (defining
a new configuration, adding or removing axes) using the instructions #SET AX, #FREE AX
and #CALL AX.
CHAXISNAME
List of the axes of the channel.
This parameter shows the table to define the names of the axes. Parameter CHNAXIS sets
the number of axes of the channel.
CHAXISNAME
CHAXISNAME n
CHAXISNAME n
Name of the axes.
Possible values: Any axes defined in AXISNAME.
Default value: Starting from CHAXISNAME1; X, Y, Z...
Associated variable: (V.)[ch].MPG.CHAXISNAMEn
Parameter included in the CHAXISNAME table.
Any axis defined by parameter AXISNAME may belong to the channel.
When defining the axes, bear in mind that the order in which they are defined determines
their index in the channel. The index of the first axis of the table will be ·1· and so on. As
with the axis name, the index in the channel permits identifying the axis in PLC variables,
marks, etc.
CHAXISNAME n
CHAXISNAME 1
CHAXISNAME 2
CHAXISNAME 3
The order of the axes and work planes (mill model).
The order of the axes in the channel sets the main work planes, those selected with functions
G17, G18 and G19. Function G20 may be used to form any work plane with the axes of the
channel.
Plane.
G17
G18
G19
The order of the axes and work planes (lathe model).
The order of the axes of the channel and parameter GEOCONFIG set the main work planes.
Refer to the parameter for further detail.
Name of the axes.
Index in the channel.
Index ·1·.
Index ·2·.
Index ·3·.
Abscissa axis. Ordinate axis.
CHAXISNAME 1 CHAXISNAME 2
CHAXISNAME 3 CHAXISNAME 1
CHAXISNAME 2 CHAXISNAME 3
Longitudinal axis.
CHAXISNAME 3
CHAXISNAME 2
CHAXISNAME 1
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·121·