Tool Manager Modifiable Signals - Fagor CNC 8060 Installation Manual

6.13
6.
CNC 8060
CNC 8065
(R : 1709)
EF
·440·

Tool manager modifiable signals.

SETTMEM
There is a mark for each magazine. The mnemonics for each magazine are the following.
SETTMEMZ1 (can also be programmed as SETTMEM)
SETTMEMZ2
The PLC sets this mark high (=1) to activate the tool manager emergency.
RESTMEM
There is a mark for each magazine. The mnemonics for each magazine are the following.
RESTMEMZ1 (can also be programmed as RESTMEM)
RESTMEMZ2
The PLC sets this mark high (=1) to cancel the tool manager emergency.
CUTTINGON
There is a mark for each channel. The mnemonics for each channel are the following.
CUTTINGONC1 (same as CUTTINGON)
CUTTINGONC2
When associating a maximum life span to a tool (monitoring), the CNC checks this mark to
find out whether the tool is machining (=1) or not (=0).
PRG
()= CNCRD (G.GS0, R300, M12)
Register R300 shows the status of the G functions.
AUTOMAT AND INCYCLE AND NOT B0R300 = CUTTINGON
If it is in automatic mode (AUTOMAT), a (INCYCLE) block is being executed and the
G00 function is not active, then, the tool is considered to be machining.
END
TREJECT
There is a mark for each channel. The mnemonics for each channel are the following.
TREJECTC1 (can also be programmed as TREJECT)
TREJECTC2
If the PLC sets this mark high (=1), the CNC interprets that the tool must be rejected.
MZTOCH1
There is a mark for each magazine. The mnemonics for each magazine are the following.
MZTOCH1MZ1 (can also be programmed as MZTOCH1)
MZTOCH1MZ2
Use it with an asynchronous magazine or synchronous with arm. The PLC must set this mark
high (=1) after taking the tool from the magazine to the changer arm 1.
CH1TOSPDL
There is a mark for each magazine. The mnemonics for each magazine are the following.
CH1TOSPDLMZ1 (same as CH1TOSPDL)
CH1TOSPDLMZ2
Use it with an asynchronous magazine or synchronous with arm. The PLC must set this mark
high (=1) after taking the tool from the changer arm 1 to the spindle.
SETTMEMZ3 SETTMEMZ4
RESTMEMZ3 RESTMEMZ4
CUTTINGONC3 CUTTINGONC4
TREJECTC3 TREJECTC4
MZTOCH1MZ3 MZTOCH1MZ4
CH1TOSPDLMZ3 CH1TOSPDLMZ4
I n s ta ll a t io n ma n u a l.