Configuring The Spindles Of The System - Fagor CNC 8060 Installation Manual

2.3.6
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·76·

Configuring the spindles of the system.

NSPDL
Number of spindles governed by the CNC.
Possible values: From 0 to 6.
Default value: 1.
Associated variable: (V.)MPG.NSPDL
This parameter sets the number of spindles of the system, whether they are servo-controlled
or not.
Bear in mind that the number of spindles does not depend on the number of channels. A
channel may have one, several or no spindles associated with it.
SPDLNAME
List of spindles of the system.
This parameter shows the table to define the names of the spindles. Parameter NSPDL sets
the number of spindles of the system.
SPDLNAME
SPDLNAME n Name of the spindles.
SPDLNAME n
Name of the spindles.
Possible values: S, S1··S9.
Default value: Starting from SPDLNAME1; S, S1...
Associated variable: (V.)MPG.SPDLNAMEn
Parameter included in the SPDLNAME table.
The spindle name is defined by 1 or 2 characters. The first character must be the letter -S-
. The second character is optional and will be a numerical suffix between 1 and 9. This way,
the name of the spindles may be within the range S, S1 ... S9.
When defining the spindles, bear in mind that the order in which they are defined determines
their logic number. The logic numbering of the spindles continues from the last logic axis;
hence, in a 3-axis system, the first spindle of the table will be logic spindle ·4· and so on.
AXISNAME SPDLNAME
AXISNAME 1
AXISNAME 2
AXISNAME 3
SPDLNAME 1
I n s ta ll a t io n ma n u a l.
Logic order.
Logic number ·1·.
Logic number ·2·.
Logic number ·3·.
Logic number ·4·.