Axis Lubrication - Fagor CNC 8060 Installation Manual

2.6.16
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·226·

Axis lubrication.

DISTLUBRI
Distance to move to lubricate the axis.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 2000000000 mm.
Possible values (2): From 0 to 78739920 inch.
Possible values (3): From 0 to 2000000000 degrees.
Default value: 0 (no lubrication).
Associated variable: (V.)[ch].MPA.DISTLUBRI[set].xn
The PLC reads this parameter in mm instead of doing it in tenths of a micron (0.0001 mm).
The lubrication signal is activated after travelling the distance indicated in this parameter.
The CNC logic inputs and outputs: LUBR(axis), LUBRENA(axis) and LUBROK(axis) must
be used in order for the PLC lubricates the axes and gears.
1 The LUBRENA(axis) mark indicates whether this feature is to be used or not.
2 When the axis has traveled the distance set by parameter DISTLUBRI, the CNC turns
the LUBR(axis) mark on to let the PLC know that it must lubricate the axis.
3 After lubricating the axis, the PLC sets the LUBROK(axis) mark high (=1) to let the CNC
know that the axis has been lubricated.
4 The CNC sets the LUBR(axis) mark low (=0) and resets its count to "0".
I n s ta ll a t io n ma n u a l.