Spindle Synchronization - Fagor CNC 8060 Installation Manual

2.3.34
2.
2.3.35
CNC 8060
CNC 8065
(R : 1709)
EF
·116·

Spindle synchronization.

SYNCCANCEL
Cancels the spindle synchronization.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)MPG.SYNCCANCEL
This parameter indicates whether the CNC cancels spindle synchronization or not after
executing M02, M30 or after an error or reset.
Define the number of jog panels and their relationship with the channels.
NKEYBD
Number of jog panels.
Possible values: From 1 to 8.
Default value: 1.
Associated variable: (V.)MPG.NKEYBD
Number of jog panels.
KEYBDCH
List of jog panels of the system.
This parameter shows the table to assign the jog panels to the channels.
KEYBDCH
KEYBDnCH Channel to which the jog panel is assigned.
The CNC numbers the operator panels following the order (sequence) that they occupy in
the CAN bus (Address switch). The first jog panel will be the one with the lowest number
and so on.
KEYBDnCH
Channel to which the jog panel is assigned.
Possible values: Active channel / CH1 / CH2 / CH3 / CH4.
Default value: Active channel.
Associated variable: (V.)MPG.KEYBDCH[jog]
Parameter included in the KEYBDCH table.
Each jog panel may be assigned to a particular channel or always to the active channel.
When a jog panel is assigned to a channel, it is always operative even if the channel is not
the active one. When there are several jog panels assigned to the same channel, operations
may be carried out from any of them indistinctively.
I n s ta ll a t io n ma n u a l.