Variables - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
14.14 Subroutine associated with the command #INITIALSUB.
Subroutine specifically for the laser model. The subroutines supplied by Fagor provide basic laser
management, so they should be configured appropriately by the OEM. The OEM is responsible for
ensuring that the subroutine complies with all safety aspects relating to handling the laser.
The command #INITIALSUB has an associated subroutine, which is executed by the CNC
along with the command. This command specifically for laser machines, where this
subroutine must perform the initial laser operations.
14.14.1 Configure the subroutines.
If this version is updated, the CNC behaves as follows.
• For the two first two installation options, the CNC will only copy the subroutines in the folder
..\Mtb\Sub if they do not already exist.
• In the third installation option, "rename previous version and install it completely", the CNC always
updates the subroutines.
Assign the subroutine to the command.
Parameter.
INITIALSUB
[CHN] ....... General machine parameter of the channel.
Name and location of the subroutine.
This subroutine must be defined in the general parameter INITIALSUB (by default,
Initialsub.fst) and saved in the folder ..\Mtb\Sub. If there are several channels, there may be
a different subroutine for each channel.
Since it is an OEM subroutine with an .fst extension, the CNC loads this subroutine into the
RAM of the CNC. See

14.14.2 Variables.

The following variables may be accessed from (PRG) the part-program and from the
MDI/MDA mode, PLC and (INT) from an external application. For each variable, the table
indicates whether the access is reading (R) or writing (W).
Variable.
(V.)[ch].MPG.INITIALSUB
Subroutine associated with the command #INITIALSUB.
Units: Text.
Syntax.
·ch· Channel number.
[2].MPG.INITIALSUB
Meaning.
CHN Subroutine associated with the command #INITIALSUB.
"14.1 Run subroutines from RAM (extension *.fst)."
Channel ·2·.
on page 617.
PRG PLC INT
- - R
14.
CNC 8060
CNC 8065
(R : 1709)
EF
·633·