Tool Manager Consulting Signals - Fagor CNC 8060 Installation Manual

6.6
6.
CNC 8060
CNC 8065
(R : 1709)
EF
·412·

Tool manager consulting signals.

TMOPERATION
There is a register for each channel. The mnemonics for each channel are the following.
TMOPERATIONC1 (same as TMOPERATION)
TMOPERATIONC2 TMOPERATIONC3 TMOPERATIONC4
This register indicates the type of operation to be carried out by the tool manager.
TMOPSTROBE
There is a mark for each channel. The mnemonics for each channel are the following.
TMOPSTROBEC1 (same as TMOPSTROBE)
TMOPSTROBEC2
The CNC sets this mark high (=1) to let the PLC know that it must execute the operation
indicated by TMOPERATION.
LEAVEPOS
There is a register for each magazine. The mnemonics for each magazine are the following.
LEAVEPOSMZ1 (can also be programmed as LEAVEPOS)
LEAVEPOSMZ2
This register indicates the magazine position to leave the tool. While selecting a turret
position (#ROTATEMZ instruction), this register takes the value of ·0· if it is a positive relative
positioning and the value of ·1· if it is a negative relative positioning.
TAKEPOS
There is a register for each magazine. The mnemonics for each magazine are the following.
TAKEPOSMZ1 (can also be programmed as TAKEPOS)
TAKEPOSMZ2
This register indicates the magazine position of the tool to be taken. While selecting a turret
position (#ROTATEMZ instruction), this register takes the value of ·0· if it is an absolute
positioning and the value of ·1· if it is a relative positioning.
NEXTPOS
There is a register for each magazine. The mnemonics for each magazine are the following.
NEXTPOSMZ1 (can also be programmed as NEXTPOS)
NEXTPOSMZ2
This register indicates the magazine position occupied by the next tool. While selecting a
turret position (#ROTATEMZ instruction); in an absolute positioning, this register indicates
the position to reach and, in a relative positioning, the number of positions to rotate.
TWORNOUT
There is a mark for each channel. The mnemonics for each channel are the following.
TWORNOUTC1 (can also be programmed as TWORNOUT)
TWORNOUTC2
The CNC channel sets this mark high (=1) to "tell" the PLC that the tool has been rejected
because it is worn out (real life > maximum life span).
TMOPSTROBEC3 TMOPSTROBEC4
LEAVEPOSMZ3 LEAVEPOSMZ4
TAKEPOSMZ3 TAKEPOSMZ4
NEXTPOSMZ3 NEXTPOSMZ4
TWORNOUTC3 TWORNOUTC4
I n s ta ll a t io n ma n u a l.