I n s t a l l a t i o n m a n u a l .
2.5.18
Radius / diameter.
DIAMPROG
Programming in diameters.
Parameter valid for a linear axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.DIAMPROG.xn
The CNC takes this parameter into consideration only when FACEAXIS = Yes.
On turning machines, the coordinates of the cross axis may be programmed in either radius
or diameter. To change the type of coordinates via program, use function G151 or G152.
2.
CNC 8060
CNC 8065
(R
: 1709)
EF
·173·