Name: Sub_Probe_Tool_Begin.fst; Sub_Probe_Tool_End.fst; Subroutines Associated With The Tool Calibration Cycle - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
14.6

Subroutines associated with the tool calibration cycle.

The subroutines supplied by Fagor provide basic probe management, so they should be adjusted and
configured appropriately by the OEM. Fagor provides the subroutine Sub_Probe_Tool_Begin.fst
associated with probe input 1 and the subroutine Sub_Probe_Piece_Begin.fst associated with probe
input 2.
The tool calibration cycle, for both the ISO and the editor, has two associated subroutines
that the CNC executes before and after the cycle. These subroutines can be used to enable
the probe and indicate if it is in safe mode.
Name.
Sub_Probe_Tool_Begin.fst

Sub_Probe_Tool_End.fst

Subroutines and M functions defined in the cycle.
Up to 4 M functions may be defined in each probing cycle to be executed before the cycle
and another 4 M functions to be executed afterwards. All these functions may have a
subroutine associated with them. When starting the execution, the cycle first executes the
subroutine Sub_Probe_Tool_Begin.fst and then the M-before functions with their associated
subroutines. At the end of the execution, the cycle executes first the M-after functions with
t h e i r c o r r e s p o n d i n g a s s o c i a t e d s u b r o u t i n e s a n d t h e n t h e s u b r o u t i n e
Sub_Probe_Tool_End.fst.
Management of the PROBE1ENA/PROBE2ENA marks in the
subroutine.
These mark indicate that the probe has is enabled. It is recommended that the OEM
manages both marks from the subroutine Sub_Probe_Tool_Begin.fst, so that execution
waits until the mark is active.
Management of the PROBE1MONIT/PROBE2MONIT marks in the
subroutine.
These marks are associated with the safe mode of the probe. It is recommended that the
OEM manages both marks from the subroutine Sub_Probe_Tool_Begin.fst to warn, should
they be deactivated, that the probe is in non-safe mode.
14.6.1 Configure the subroutines.
Name and location of the subroutine.
The name of the subroutine is Sub_Probe_Tool_Begin.fst and Sub_Probe_Tool_End.fst.
Both subroutines must be saved in the folder ..\Mtb\Sub. All channels use the same
subroutines.
Since it is an OEM subroutine with an .fst extension, the CNC loads this subroutine into the
RAM of the CNC. See
Meaning.
Subroutine associated with the beginning of the tool calibration
cycle.
Subroutine associated with the end of the tool calibration cycle.
"14.1 Run subroutines from RAM (extension *.fst)."
14.
CNC 8060
CNC 8065
on page 617.
(R
EF
: 1709)
·623·