Block Search - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
2.4.15

Block search.

FUNPLC
Send the M, H, S functions to the PLC during block search.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.FUNPLC
With block search, it is possible to recover the program history up to a particular block, that
may be in a program or in a subroutine, in such way that if program execution is resumed
at that block, it will do so with the same conditions as if it were executed from the beginning.
This parameter determines whether or not the CNC sends the M, H, S functions to the PLC
during block search. The M function table has an MPLC field to define whether the CNC
sends the function to the PLC or not. All M functions set in the table will be sent out to the
PLC or not depending on this field regardless of the setting of machine parameter FUNPLC.
FUNPLC
Yes
No
2.4.16 Interruption subroutines.
SUBINTSTOP
Execute interruption subroutines while the program is stopped or
while no program is in execution.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.SUBINTSTOP
This parameter determines whether the CNC must execute the interruption subroutine when
the program is interrupted (STOP) or no program is in execution (channel in READY state).
In order to execute the subroutine when no program is in execution, the channel must be
in automatic mode; the subroutine cannot be executed from jog mode.
Meaning.
In this case, the functions are sent out to the PLC during block search as they
are being read. Once block search ends and after repositioning the axes, the
CNC shows the "MHSF" softkey for executing any function of this type, thus
modifying the machining conditions.
In this case, the functions are not sent out to the PLC during block search. After
the search, the CNC screen shows the history of those functions so the user can
enable them in the desired order.
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·147·