Work Sets - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
2.5.27

Work sets.

NPARSETS
Number of parameter sets available.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 1 to 4.
Default value: 1.
Associated variable: (V.)[ch].MPA.NPARSETS.xn
Up to 4 different parameter sets may be defined to indicate the dynamics of the axis in each
one of them (feedrates, gains, accelerations, etc.).
DEFAULTSET
Set of default parameters on power-up.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 4.
Default value: 1.
Associated variable: (V.)[ch].MPA.DEFAULTSET.xn
Axis behavior:
For the axes, the parameter DEFAULTSET indicates the parameter set assumed by the CNC
during power-up, after executing an M02 or M30 or after a reset. When defined with a "0"
value, the parameter set is always maintained. To select a parameter set on the axis or via
the part-program, use function G112.
Spindle behavior.
For the spindles, the parameter DEFAULTSET is not used either in the start-up or in the reset;
both circumstances are managed from the PLC maneuver. During power-up, the CNC uses
the set indicated by the PLC; if there is no set indicated, then the CNC starts-up without a
set. After a reset, the CNC uses the set indicated by the PLC; if there is no set indicated,
then the CNC remains as it is.
The parameter DEFAULTSET is only used when moving the spindle for the first time without
a set and without S programmed. In this case, the CNC uses the set indicated in the
parameter DEFAULTSET. If DEFAULTSET is set at the value of ·0·, the CNC uses the set
of 1.
• The CNC starts-up without a set, and just after starting-up the CNC runs an M19 or G74.
• The CNC starts-up without a set, and just after starting-up the spindles that do not have
the SYNCSET parameter defined are synchronized.
• If the Sercos ring falls and the drive uses the default set.
If the CNC starts-up without a set, when the spindle starts-up for the first time (M3/M4 with
S programmed) the CNC uses the appropriate set, which id dependant on S.
The start-up and reset do not use the parameter DEFAULTSET; both circumstances are
managed from the PLC maneuver. During power-up, the CNC uses the set indicated by the
PLC; if there is no set indicated, then the CNC starts-up without a set. After a reset, the CNC
uses the set indicated by the PLC; if there is no set indicated, then the CNC remains as it is.
To select a parameter set on a spindle from the part-program and make a gear change, use
functions M41 through M44.
SET n
Work sets.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
It shows the machine parameter table of the set.
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·191·