Work Modes And Software Protection At The Cnc - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
1.1.1

Work modes and software protection at the CNC.

Fagor delivers the unit with write-protected disk, except for the folders or files that must be
unprotected for the normal operation of the CNC. The changes made to protected folders
or files will be operative until the unit is turned off and back on, the CNC will then restore
the initial configuration. The changes made to unprotected areas of the disk will remain.
The disk has been pre-configured with three access modes, each offers a different protection
level. The unit shows the active work mode with an icon on the task bar of the operating
system, next to the clock. When the CNC is turned on, the status bar shows the active work
mode with icons.
Icon. Work mode.
Administrator mode.
Setup mode.
User mode.
i
These work modes will not be available when upgrading the software from a version where the unit
has a disk that is not write-protected (not read-only). Since it is not write-protected, the changes made
to it will remain.
Work mode change (diskMonitor window).
• Having the CNC application turned off, the work mode change is done using the [ALT][D]
or with icon indicating the active work mode, on the task bar of the operative system (next
to the clock). In either case, the unit shows the DiskMonitor window to switch from one
work mode to another. This process implies restarting the unit and if the manufacturer
has set it up this way, it will also be necessary to enter the corresponding password.
• Having the CNC started up in any work mode, the [ALT][D] hotkey shows the DiskMonitor
window to change from one work mode to another. This process implies restarting the
unit and if the manufacturer has set it up this way, it will also be necessary to enter the
corresponding password.
• The desired work mode may be selected from the utilities mode, from the softkey menu.
This process implies restarting the unit and if the manufacturer has set it up this way, it
will also be necessary to enter the corresponding password.
1.
CNC 8060
CNC 8065
(R : 1709)
EF
·45·