Configuration Of The Probing Movement - Fagor CNC 8060 Installation Manual

2.5.20
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·176·

Configuration of the probing movement.

PROBEAXIS
The axis can participate in probing movements.
Parameter valid for linear and rotary axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.PROBEAXIS.xn
This parameter indicates whether the axis is involved in a probing move (G100).
PROBERANGE
Maximum braking distance.
Parameter valid for linear and rotary axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 99999.9999 mm/min.
Possible values (2): From 0 to 3937.00787 inch/min.
Possible values (3): From 0 to 99999.9999 degrees/min.
Default value: 1.0000 mm / 0.03937 inch / 1.0000 degree.
Associated variable: (V.)[ch].MPA.PROBERANGE.xn
This parameter sets the maximum braking distance for the probe after probing to avoid
breaking it (ceramic, etc). The CNC issues an error messages when this distance is
exceeded.
PROBEFEED
Maximum probing feedrate.
Parameter valid for linear and rotary axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 36000000.0000 mm/min.
Possible values (2): From 0 to 1417322.83465 inch/min.
Possible values (3): From 0 to 36000000.0000 degrees/min.
Default value: 100.0000 mm/min / 3.93701 inch/min / 100.0000 degrees/min.
Associated variable: (V.)[ch].MPA.PROBEFEED.xn
The value of this parameter must be smaller than the feedrate needed to brake within the
distance set by PROBERANGE with the acceleration and jerk values of the axis. Otherwise,
it will show a warning when validating the axis parameters indicating the maximum feedrate
that may be reached.
PROBEDELAY
Delay for the "probe 1" signal.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Within ±100000.0000 ms.
Default value: 0 (no delay).
Associated variable: (V.)[ch].MPA.PROBEDELAY.xn
See axis machine parameters PROBEDELAY2.
PROBEDELAY2
Delay for the "probe 2" signal.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Within ±100000.0000 ms.
Default value: 0 (no delay).
Associated variable: (V.)[ch].MPA.PROBEDELAY2.xn
Parameter PROBEDELAY corresponds to the probe set by PRBID1 and PROBEDELAY2
to the probe set by PRBID2.
In some types of probes, there is a short delay of a few milliseconds from the probing instant
to when the CNC actually receives the signals (infrared communication, etc.). In these cases,
I n s ta ll a t io n ma n u a l.