Configuration Of The Hsc Mode - Fagor CNC 8060 Installation Manual

2.6.13
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·216·

Configuration of the HSC mode.

HSC
Parameter table of the HSC mode.
This parameter shows the table to define the HSC work mode.
HSC
CORNERACC Maximum acceleration permitted at the corners.
CURVACC Maximum contouring acceleration permitted.
CORNERJERK Maximum Jerk permitted at the corners.
CURVJERK Maximum contouring Jerk permitted.
FASTACC Maximum acceleration permitted (FAST mode).
MAXERROR Position error.
CONTERROR Tolerance per axis.
These parameters help increase or decrease the acceleration and jerk limits on curved path,
due to the centripetal acceleration and at path joints, without affecting the way the axis
accelerates or decelerates.
CORNERACC
Maximum acceleration permitted at the corners.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 100000.0000 mm/s².
Possible values (2): From 0 to 3937.00787 inch/s².
Possible values (3): From 0 to 100000.0000 grados/s².
Default value: 0.
Associated variable: (V.)[ch].MPA.CORNERACC[set].xn
This parameter sets the maximum acceleration allowed for the axis during block transition.
If this parameter is set with a ·0· value, the maximum acceleration of the axis is respected.
CURVACC
Maximum contouring acceleration permitted.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 100000.0000 mm/s².
Possible values (2): From 0 to 3937.00787 inch/s².
Possible values (3): From 0 to 100000.0000 grados/s².
Default value: 0.
Associated variable: (V.)[ch].MPA.CURVAACC[set].xn
If this parameter is set with a ·0· value, the maximum acceleration of the axis is respected.
CORNERJERK
Maximum Jerk permitted at the corners.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): De 0 a 1E+009 mm/s³.
Possible values (2): De 0 a 39370078.74016 inch/s³.
Possible values (3): De 0 a 1E+009 grados/s³.
Default value: 0.
Associated variable: (V.)[ch].MPA.CORNERJERK[set].xn
If this parameter is set with a ·0· value, the maximum jerk of the axis is respected.
I n s ta ll a t io n ma n u a l.