Key Codes - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
8.2

Key codes.

The key codes (scan codes) may be used to determine which is the last key accepted by
the CNC and also to simulate the keyboard from the PLC. Each key is assigned two codes;
one for pressing it and another one for releasing it. The code does not depend on the key
(printed character), but rather its position on the keyboard (keyboard layout). For example,
the code $27 on a "Spanish (Spain)" keyboard layout corresponds to the character "Ñ" and
on an "English (United States)" keyboard layout, it corresponds to the character ";". See
"8.5.1 Scan codes. "Spanish (Spain)" keyboard layout."
codes. Keyboard distribution "English (United States)"."
CNC's own keys.
The keys of the CNC have no associated key code.
• The [START], [STOP] and [RESET] keys may be actuated from the PLC using the
CYSTART, _STOP and RESETIN keys respectively.
• The keys that have an associated hotkey, such as those for accessing work modes, may
be simulated through their hotkeys.
• Keys that do not have an associated hotkey cannot be simulated.
• The Fagor logo key cannot be simulated. This key is not found on all keyboards.
The task window ([CTRL] + [A]) shows the list of available hotkeys for the CNC.
on page 527. See "8.5.2 Scan
on page 528. 8.
CNC 8060
CNC 8065
(R : 1709)
EF
·523·