Zero Offsets - Fagor CNC 8060 Installation Manual

2.3.38
2.
2.3.39
CNC 8060
CNC 8065
(R : 1709)
EF
·118·

Zero offsets.

FINORG
Fine definition of zero offsets.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)MPG.FINEORG
This parameter enables the possibility to set each zero offset in the zero offset table with a
coarse (or absolute) value and a fine (incremental) one. When executing function G159, the
CNC assumes as new zero offset the sum of both parts.
• Absolute zero offset table (without fine setting of the zero offset).
• Absolute zero offset table (with fine setting of the zero offset).
Remote module RCS-S (Sercos Counter).
NSERCOUNT
Number of Sercos counter nodes in the bus.
Possible values: From 0 to 8.
Default value: 0.
Number of RCS-S modules in the bus.
SERCOUNTID n
Table of thumbwheel identifiers associated to the Sercos
counters.
Possible values: From 1 to 15.
These parameters may be used to assign a logic number to the RCS-S modules of the bus
based on their physical address, set by its rotary switch (node number). Define in each
parameter the address (node number) of the RCS-S module.
Although the Sercos ring may have up to 32 nodes, the RCS-S modules always occupy
positions from 1 to 15.
i
If drives and RCS-S modules are going to coexist on the Sercos bus, in order to achieve better system
performance, it is recommended to assign the drives the lower node numbers.
I n s ta ll a t io n ma n u a l.