Set The Tolerance For An Axis Located At The Software Travel Limits - Fagor CNC 8060 Installation Manual

11.6.2
11.
CNC 8060
CNC 8065
(R : 1709)
EF
·584·

Set the tolerance for an axis located at the software travel limits.

The tolerance for the software travel limits is set with machine parameter SWLIMITTOL. The
CNC applies this tolerance to the active software limits.
Parameter. Meaning.
SWLIMITTOL Software limit tolerance.
This tolerance indicates the maximum variation or oscillation allowed to a real coordinate
of an axis referred to the software limits, before issuing an error indicating travel limit overrun.
The programmed theoretical movement of the axis is only possible up to the exact limit, but
the real axis coordinate is allowed this margin before the error is issued. When they are DRO
axes, the error is also issued when the real coordinate exceeds the limit over the tolerance.
When no theoretical movement has been programmed, the limit overrun error will only be
issued when exceeding the tolerance in a sampling period (cycle time); for example, when
hitting the axis causing it to overrun the limits abruptly. In any other case, if no theoretical
movement has been programmed for the axis, the error will not be issued even if it overruns
the limits.
I n s ta ll a t io n ma n u a l.