Connecting The Gap Sensor - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
16.1.1

Connecting the gap sensor.

The analog input for the sensor can be installed in remote CAN modules or on the Sercos
drive of any axis. Fagor Automation recommends using a drive input. Use the machine
parameters GAPANAINTYPE and GAPANAINID to define the CNC where the sensor input
is located. See
Electrical diagram.
Connecting the sensor to an analog input of the Sercos drive.
The example uses the first analog input of the drive (pins ·4· and ·5·); to use the second input,
use pins ·2· and ·3.
CNC
The analog inputs of the drive are a hardware option; to access them, the drive must have a
communications interface with the analog inputs A1 or SI.
Connecting a sensor to an analog input on remote modules.
The analog inputs are available on modules RIO5 and RIOR.
CNC
"16.1.4 Configuring the gap sensor."
4
X7
AI1-
5
AI1+
SERCOS
DRIVE
9
AI1-
I48
11
AI1+
CAN
RIOR
on page 674.
ANALOG INPUT -
ANALOG INPUT +
GAP SENSOR
ANALOG INPUT -
ANALOG INPUT +
GAP SENSOR
16.
CNC 8060
CNC 8065
(R : 1709)
EF
·671·