Repositioning Of The Axes In Tool Inspection - Fagor CNC 8060 Installation Manual

2.5.21
2.
2.5.22
CNC 8060
CNC 8065
(R : 1709)
EF
·178·

Repositioning of the axes in tool inspection.

REPOSFEED
Maximum repositioning feedrate.
Parameter valid for linear and rotary axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 200000.0000 mm/min.
Possible values (2): From 0 to 7874.01575 inch/min.
Possible values (3): From 0 to 36000000.0000 degrees/min.
Default value: 0.
Associated variable: (V.)[ch].MPA.REPOSFEED.xn
Repositioning feedrate after a tool inspection or an interruption subroutine. If not defined,
the CNC assumes as repositioning feedrate the one defined for the continuous jog mode
(parameter JOGFEED). The value of parameter REPOSFEED must always be lower than
G00FEED, MAXMANFEED and JOGRAPFEED.
Configuration of the independent axis.
POSFEED
Positioning feedrate.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values (1): From 0 to 200000.0000 mm/min.
Possible values (2): From 0 to 7874.01575 inch/min.
Possible values (3): From 0 to 36000000.0000 degrees/min.
Possible values (4): From 0 to 100000.0000 rpm.
Default value: 1000.0000 mm/min / 39.37008 inch/min / 1000.0000 degrees/min / 1000 rpm.
Associated variable: (V.)[ch].MPA.POSFEED.xn
Positioning feedrate of the independent axis.
I n s ta ll a t io n ma n u a l.