Encoder Information - Fagor CNC 8060 Installation Manual

2.6.23
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·234·

Encoder Information.

ENCODERINFO
Encoder Information.
When the type of feedback is FeeDat or EnDat (FEEDBACKTYPE parameter), this
parameter displays a parameter table with the encoder information.
Parameter. Meaning.
NAME Encoder nomenclature.
TYPE Type of encoder.
RESOLUTION Encoder resolution.
SERIALNUMBER Encoder serial number.
DATALENGTH Number of data bits in the transmission.
The CNC obtains this information from the encoder itself, and therefore these
parameters cannot be modified. If the data read from the encoder do not match
those saved in the parameter table, the CNC will display a new table with both
groups of values. At the same time, it will display a softkey to save the new data
in the table. The CNC will only display this softkey if the data read from the encoder
are valid (the encoder is connected and correctly identified) and they do not match
those already saved.
NAME
Encoder nomenclature.
Associated variable (value saved in the table): (V.)[ch].MPA.DE_NAME[set].xn
Associated variable (value read on the encoder): (V.)[ch].A.CDE_NAME[set].xn
Parameter cannot be modified; the CNC reads this parameter from the encoder.
• If it is a Fagor encoder, the name of the encoder.
• If it is an EnDat encoder, the "EnDat" text.
TYPE
Encoder type.
Associated variable (value saved in the table): (V.)[ch].MPA.DE_TYPE[set].xn
Associated variable (value read on the encoder): (V.)[ch].A.CDE_TYPE[set].xn
Parameter cannot be modified; the CNC reads this parameter from the encoder.
Encoder type (multi-turn absolute rotary, absolute rotary, absolute linear, etc).
RESOLUTION
Encoder resolution.
Associated variable (value saved in the table): (V.)[ch].MPA.DE_RESOLUTION[set].xn
Associated variable (value read on the encoder): (V.)[ch].A.CDE_RESOLUTION[set].xn
Parameter cannot be modified; the CNC reads this parameter from the encoder.
• If the encoder is linear, nanometer resolution.
• If the encoder is angular, the number of pulses per turn.
SERIALNUMBER
Encoder serial number.
Associated variable (value saved in the table): (V.)[ch].MPA.DE_SERIALNUMBER[set].xn
Associated variable (value read on the encoder): (V.)[ch].A.CDE_SERIALNUMBER[set].xn
Parameter cannot be modified; the CNC reads this parameter from the encoder.
I n s ta ll a t io n ma n u a l.