Tandem Related Variables - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
11.2.4

Tandem related variables.

Variables related to general machine parameters.
These variables are read-only synchronous and are evaluated during block preparation.
They have generic names. Replace the letter "nb" with numbers, keeping the brackets.
Variable
(V.)MPG.TMASTERAXIS[nb]
Tandem [nb]. Logic number of the master axis
(V.)MPG.TSLAVEAXIS[nb]
Tandem [nb]. Logic number of the slave axis
(V.)MPG.TORQDIST[nb]
Tandem [nb]. Torque distribution
(V.)MPG.PRELOAD[nb]
Tandem [nb]. Preload
(V.)MPG.PRELFITI[nb]
Tandem [nb]. Time to apply the preload
(V.)MPG.TPROGAIN[nb]
Tandem [nb]. Proportional gain
(V.)MPG.TINTIME[nb]
Tandem [nb]. Integral gain
(V.)MPG.TCOMPLIM[nb]
Tandem [nb]. Compensation limit
Tandem related variables.
These variables are read/write (R/W) synchronous and are evaluated during execution.
They correspond to linear and rotary axes and to the spindle. The mnemonics of the variables
have generic names.
• Replace "Xn" with the name or logic number of the axis.
• Replace the "ch" character with the channel number, maintaining the brackets.
(V.)[ch].A.TPIIN.xn
Input of the PI of the master axis of the tandem (in rpm)
(V.)[ch].A.TPIOUT.xn
Output of the PI of the master axis of the tandem (in rpm)
(V.)[ch].A.TFILTOUT.xn
Output of the pre-load filter
(V.)[ch].A.PRELOAD.xn
Preload
(V.)[ch].A.FTEO.xn
Velocity command for Sercos
(V.)[ch].A.TORQUE.xn
Current torque in Sercos
(V.)A.TPIOUT.[Xn] (V.)A.TPIIN.[Xn]
The axis must be a valid tandem master, otherwise, it returns a value of zero.
(V.)A.TORQUE
The PLC reading of this variable comes in tenths (x10).
PRG PLC INT
R R R
R R R
R R R
R R R
R R R
R R R
R R R
R R R
PRG PLC INT
R R R
R R R
R R R
R/W R/W R/W
R R R
R R R
11.
CNC 8060
CNC 8065
(R : 1709)
EF
·559·