Name: Kincal_Begin.nc; Kincal_End.nc; Subroutines Associated With The Kinematics Calibration Cycle - Fagor CNC 8060 Installation Manual

14.5
14.
14.5.1
CNC 8060
CNC 8065
(R : 1709)
EF
·622·

Subroutines associated with the kinematics calibration cycle.

The kinematics calibration cycle has two associated subroutines (KinCal_Begin.nc and
KinCal_End.nc), which the CNC executes before and after the cycle.
Name.
KinCal_Begin.nc

KinCal_End.nc

Fagor supplies both subroutines as incomplete and it is the manufacturer's responsibility to
define both subroutines. Software updates do not modify any existing subroutines.
Configure the subroutines.
Name and location of the subroutine.
The names of the subroutines are KinCal_Begin.nc and KinCal_End.nc. Both subroutines
must be saved in the folder ..\Mtb\Sub. All channels use the same subroutines.
Meaning.
Subroutine associated with the beginning of the kinematics
calibration cycle.
Subroutine associated with the end of the kinematics calibration
cycle.
I n s ta ll a t io n ma n u a l.