Rapid Traverse For The Automatic Mode - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
2.4.18

Rapid traverse for the automatic mode

RAPIDEN
It is used to enable rapid traverse for the automatic mode.
Possible values: Disabled / EXRAPID or rapid key / EXRAPID and rapid key.
Default value: Disabled.
Associated variable: (V.)[ch].MPG.RAPIDEN
This parameter indicates whether rapid traverse may be enabled or not during the execution
of a program for the programmed movements. Depending on the selected option, activating
rapid traverse will require activating the PLC mark EXRAPID or pressing the "rapid" key or
both.
RAPIDEN
Disabled.
EXRAPID or rapid key.
EXRAPID and rapid key.
When activating rapid traverse while executing a program, each axis will assume the
feedrate set by its parameter FRAPIDEN, as long as G0 or a thread is not active. Movements
in G0 are carried out at the feedrate set in parameter G00FEED. The threads are executed
at the programmed feedrate. The rapid traverse will also be limited by channel parameter
FRAPIDEN.
If "EXRAPID or rapid key" is the chosen option for RAPIDEN and the CNC has several channels, the
EXRAPID mark will only affect the corresponding channel. The rapid key, on the other hand, affects
simultaneously all the channels that may be affected at the time. If the active channel is in jog mode
and another channel is executing a program, when pressing the rapid key in the active channel (jog
mode), the rapid traverse will also be applied in the channel that is executing the program.
In a system where the rapid key may affect several channels at the same time, we recommend to choose
the "EXRAPID and rapid key" option or manage by PLC the behavior of the rapid key according to the
active channel and the selected work mode (jog or automatic).
FRAPIDEN
Rapid traverse in the channel for movements in automatic mode.
Possible values: From 0 to 500000.0000 mm/min / from 0 to 19685.03937 inch/min.
Default value: 0.
Associated variable: (V.)[ch].MPG.FRAPIDEN
Maximum feedrate in the channel for the program being executed, when rapid traverse for
the automatic mode is active (parameter RAPIDEN). If the parameter is set with a "0" value,
the feedrate is not limited.
This parameter does not the movements programmed in G00 or the threads. Movements
in G0 are carried out at the feedrate set in parameter G00FEED. The threads are executed
at the programmed feedrate.
Rapid traverse cannot exceed the value set in axis parameters G00FEED and FRAPIDEN
or the maximum feedrate set by PLC (variable (V.)PLC.G00FEED). Rapid traverse cannot
exceed the value set in axis parameter MAXFEED of the channel and the active feedrate
set by PLC (variable (V.)PLC.F).
Meaning.
Rapid traverse is not available for the automatic mode.
To activate the rapid feed, just activate the PLC mark EXRAPID or
press the "rapid" key of the jog panel.
To activate the rapid feed, just activate the PLC mark EXRAPID and
press the "rapid" key of the jog panel.
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·149·