Machine Parameters For Jog Mode - Fagor CNC 8060 Installation Manual

2.7
2.7.1
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·242·

Machine parameters for JOG mode.

Handwheel configuration.
NMPG
Number of handwheels connected to the CNC.
Possible values: From 0 to 12.
Default value: 0 (there are no handwheels).
Associated variable: (V.)MPMAN.NMPG
Electronic handwheels may be used to move the axes. Depending on the type of handwheel,
The CNC may have general handwheels to move any axis or individual handwheels that will
only move their associated axes. Several individual and general handwheels may be used
at the same time, up to a total of 12 handwheels. The portable operator panel HBLS does
not count as handwheel when setting this parameter.
To set the resolution of each handwheel, the distance it moves at each switch position, set
the parameter MPGRESOL.
MANPG
Table of handwheels.
This parameter shows the list of available handwheels.
MANPG n
Handwheel configuration.
This parameter shows the table to configure the handwheels. Each table shows the following
parameters to configure it.
MANPG n
COUNTERTYPE Handwheel feedback type.
COUNTERID Feedback input for the handwheel.
HWFBTYPE Feedback type associated with the handwheel input.
MPGAXIS Name of the axis associated with the handwheel.
COUNTERTYPE
Type of feedback input for the handwheel.
Possible values: Remote / Keyboard / Local / Sercos Counter.
Default value: Remote.
Associated variable: (V.)MPMAN.COUNTERTYPE[hw]
Parameter included in the MANPG table.
This parameter indicates the location of the handwheel feedback input; at the counter
modules of the remote CAN groups, at the RCS-S modules (Sercos counter) at the keyboard
or at the local feedback inputs of the central unit.
COUNTERID
Feedback input associated with the handwheel.
Possible values: From 1 to 40 if remote CAN feedback / from -1 to -9 if feedback at the keyboard / from
1 to 2 if local feedback / from 1 to 32 if feedback at RCS-S module.
Default value: 0.
Associated variable: (V.)MPMAN.COUNTERID[hw]
Parameter included in the MANPG table.
The handwheels may be connected through the keyboards (3 per keyboard) , and through
the counters modules of the remote CAN groups (4 per module), through the RCS-S counter
modules (4 per module) or through the local feedback inputs.
I n s ta ll a t io n ma n u a l.