Subroutine Associated With The Command #Finalsub - Fagor CNC 8060 Installation Manual

14.17 Subroutine associated with the command #FINALSUB.

14.
14.17.1 Configure the subroutines.
14.17.2 Variables.
CNC 8060
CNC 8065
(R : 1709)
EF
·638·
Subroutine specifically for the laser model. The subroutines supplied by Fagor provide basic laser
management, so they should be configured appropriately by the OEM. The OEM is responsible for
ensuring that the subroutine complies with all safety aspects relating to handling the laser.
The command #FINALSUB has an associated subroutine, which is executed by the CNC
along with the command. This command is specifically for laser machines, where this
subroutine must perform the final laser operations.
If this version is updated, the CNC behaves as follows.
• For the two first two installation options, the CNC will only copy the subroutines in the folder
..\Mtb\Sub if they do not already exist.
• In the third installation option, "rename previous version and install it completely", the CNC always
updates the subroutines.
Assign the subroutine to the command.
Parameter.
FINALSUB CHN
[CHN]....... General machine parameter of the channel.
Name and location of the subroutine.
This subroutine must be defined in the general parameter FINALSUB (by default,
Finalsub.fst) and saved in the folder ..\Mtb\Sub. If there are several channels, there may be
a different subroutine for each channel.
Since it is an OEM subroutine with an .fst extension, the CNC loads this subroutine into the
RAM of the CNC. See "14.1 Run subroutines from RAM (extension *.fst)."
The following variables may be accessed from (PRG) the part-program and from the
MDI/MDA mode, PLC and (INT) from an external application. For each variable, the table
indicates whether the access is reading (R) or writing (W).
Variable.
(V.)[ch].MPG.FINALSUB
Subroutine associated with the command #FINALSUB.
Units: Text.
Syntax.
·ch· Channel number.
[2].MPG.FINALSUB
Meaning.
Subroutine associated with the command #FINALSUB.
Channel ·2·.
I n s ta ll a t io n ma n u a l.
on page 617.
PRG PLC INT
- - R