Probe Setting - Fagor CNC 8060 Installation Manual

I n s t a l l a t i o n m a n u a l .
2.3.23

Probe setting.

PROBE
There is a probe.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)MPG.PROBE
This parameter indicates whether there is a probe on the machine or not. The CNC may have
configured two probes, it will usually be a tabletop probe to calibrate tools and a touch probe
to measure the part.
Tabletop probe.
PROBEDATA
Probe parameters.
This parameter shows the table of parameters needed to set up the probe. If the CNC uses
a tabletop probe, besides these parameters it is necessary to define the probe position.
PROBEDATA
PROBETYPE1
PROBETYPE2
PRBDI1
PRBDI2
PRBPULSE1
PRBPULSE2
PROBETYPE1
Probe type 1.
Possible values: Remote / Local.
Default value: Remote.
Associated variable: (V.)MPG.PROBETYPE1
Parameter included in the PROBEDATA table.
This parameter indicates the type of probe depending on where it is connected; a remote
probe if it is connected to a digital input at the remote modules or to a local probe if it is
connected to a probe input at the central unit.
PROBETYPE2
Probe type 2.
Possible values: Remote / Local.
Default value: Remote.
Associated variable: (V.)MPG.PROBETYPE2
Parameter included in the PROBEDATA table.
This parameter indicates the type of probe depending on where it is connected; a remote
probe if it is connected to a digital input at the remote modules or to a local probe if it is
connected to a probe input at the central unit.
Measuring probe.
Probe type 1.
Probe type 2.
Number of the input associated with probe 1.
Number of the input associated with probe 2.
Logic level to activate probe 1.
Logic level to activate probe 2.
2.
CNC 8060
CNC 8065
(R : 1709)
EF
·101·