Illumination During Disable Mode - Datalogic Magellan 3450VSi Product Reference Manual

Enter/Exit Programming Mode

Illumination During Disable Mode

This feature allows illumination to be turned off when the scanner is in "disable"
mode. It determines if the imager illumination is controlled by host interface
enable/disable commands.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
063A01(CR)
Illumination During Disable Mode = Enable
20
= Illumination is not controlled by host enable/disable commands,
Disable
illumination stays on when disabled.
= Illumination is controlled by host enable/disable commands, illu-
Enable
mination is on when enabled and off when disabled.
gramming Mode bar code.
Illumination During Disable Mode
063A00(CR)
Illumination During Disable Mode = Disable
DEFAULT
Magellan™ 3450VSi