Connecting The Scanner - Datalogic Magellan 3450VSi Product Reference Manual

Connecting the Scanner

Connecting the Scanner
The scanner kit you ordered to match your interface should provide a compati-
ble cable for your installation. Alternatively, if your scanner receives Power Off
the Terminal (POT) it might be possible to connect using a cable from a previ-
ously existing installation (except for USB). Check with your technical support
representative about compatibility before connecting. Use the appropriate
instructions below when you're ready to connect the scanner to the terminal, PC
or other host device.
Upon completing the connection via the appropriate interface instructions
below, proceed to the
scan the bar code to select the correct interface type.
RS-232 Serial Connection —
scanner to the terminal/PC serial port via the RS-232 cable as shown in
1. If the terminal will not support POT (Power Off the Terminal) to supply scan-
ner power, use the approved power supply (AC Adapter).
Figure 1. Connecting the Scanner
a
b
2
Interface Related Features
Turn off power to the terminal/PC and connect the
USB+Power
Power Off the
Terminal (POT)
RS-232
and USB Cables
Powered by AC Adapter
To Terminal (PC)
section of this manual and
Terminal (PC)
Magellan™ 3450VSi
Figure