Good Read When To Indicate - Datalogic Magellan 3450VSi Product Reference Manual

Enter/Exit Programming Mode

Good Read When to Indicate

This feature specifies when the scanner will provide indication (beep and/or
flash its green LEDs) upon successfully reading a bar code.
•
•
•
•
To set the Good Read When to Indicate feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired mode bar code from those provided below You'll need to
3. Complete the programming sequence by scanning the Enter/Exit Pro-
DEFAULT
009901(CR)
Good Read When to Indicate = After Transmit
009903(CR)
Good Read When to Indicate = After Each Output
Structure Proofed
32
Good Read = Indicate after decode.
Good Read = Indicate after transmit.
Good Read = Indicate after CTS goes inactive, then active.
This mode applies to RS-232 STD and RS-232 WN interfaces only. If set in
other interfaces, "Indicate after decode" mode will be implemented.
Good Read = Indicate after each output structure proofed.
When beeping after each output structure decoded, if there are multiple
output structures, there is a delay after the beep has finished. This delay is
equal to the Good Read Beep Length on page 30
cover any unused bar codes on facing pages to ensure that the scanner
reads only the bar code you intend to scan.
gramming Mode bar code.
Good Read When to Indicate
.
009900(CR)
Good Read When to Indicate = After Decode
009902(CR)
Good Read When to Indicate = After CTS goes Inactive,
Then Active
Magellan™ 3450VSi