Step 6 - Test Mode - Datalogic Matrix 120 Product Reference Manual

Step 6 - Test Mode

Use a code suitable to your application to test the reading performance of the
system.
1. Enter the
until the Test LED is on.
2. Release the button to enter the
Once entered, the Bar Graph on the five LEDs is activated and if the reader
starts reading codes, the Bar-Graph shows the Good Read Rate.
3. To exit the Test, press the X-PRESS push button once.
By default, the Test exits automatically after three minutes.
NOTE
The Bar Graph has the following meaning:
In case of No Read condition, only the STATUS LED (red) is on and blinks.
Product Reference Guide
Test
function by pressing and holding the X-PRESS push button
Figure 13 - X-PRESS Interface: Test Function
Figure 14 - Test Function Bar Graph
Test
function.
Step 6 - Test Mode
29