Enter/Exit Programming Mode
UPC-A Check Character Transmission
Enables/disables transmission of a UPC-A check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
00B701(CR)
UPC-A Check Character Transmission = Enable
118
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
gramming Mode bar code.
UPC-A Check Character Transmission
00B700(CR)
UPC-A Check Character Transmission = Disable
DEFAULT
Magellan™ 3450VSi